Wide 1500 mm roll-up
Our wide 1 500 mm roll-up gives you more face width than a standard unit, so it can sit behind a promo table and read like a small backdrop. It packs down for transport, prints in full colour, and suits indoor expo work where you need more presence without moving to a full pop-up wall.

A wider banner for small footprint display space
The 1 500 mm roll-up is a portable banner with a broad printed panel that retracts into its base for transport. It is often chosen when a standard pull-up looks too narrow, but a full fabric wall would take too much room or budget. On an expo floor it works well behind a registration table, beside a product sample plinth, or along the back of a shell scheme where you need one strong message seen from a few metres away.
This format is best treated as a mini backdrop rather than a banner for passageways. The extra width gives more design breathing room for a hero image, headline and logo block, but it also means the unit needs a flatter floor and a bit more care in handling. In busy halls that small difference matters.
- Best for indoor exhibitions, conferences and mall activations.
- Useful behind a 1.8 metre trestle table or similar promo counter.
- Good when one panel must carry a full campaign visual.
- Less suitable for narrow aisles where people brush past the edges.
Sizes, visible area and practical limits on site
The base width is 1 500 mm and the printed graphic is supplied to suit that hardware. Visible height is usually around 2 000 mm once installed, with a little allowance at the bottom for the panel to sit inside the cassette and at the top for fixing under the rail. Final artwork setup should follow the dimensions we issue for the selected unit so trim and safe areas stay correct.
Because this is a wider panel, it shows movement more readily than an 850 mm unit when placed near air-conditioning drafts, entrance doors or outdoor openings. It is still portable and easy to move, but it is not the right choice for windy forecourts or damp grass. If the venue is on the coast, especially around Durban, let the print dry fully before packing after use so moisture does not stay trapped in the carry bag.
- Nominal width: 1 500 mm.
- Typical standing height: about 2 000 mm.
- Supplied with banner cassette, support pole and carry bag.
- Intended for level indoor flooring such as carpet, laminate or smooth concrete.
Where this format reads well, and where it does not
A wide roll-up suits launches, school and college open days, hotel conference foyers, municipal information points, medical congresses and in-store promotions where setup must stay quick. It is also useful for photographers' briefing areas, sponsor walls in compact venues, and check-in points where people queue facing the graphic.
It is not a substitute for a full exhibition wall when you need edge-to-edge coverage across three metres, and it is not the right hardware for repeated outdoor wind exposure. If your stand needs a smooth-looking media wall for interviews or lots of social photos, our fabric pop-up wall is normally the cleaner route. If you only need a single message marker at a doorway, a standard 850 mm unit is easier to position and carry.
In short, this size shines when there is enough room around it to breathe, but not enough room for a large frame system.
Setup notes that save trouble on the day
Installation is straightforward, but the width means one careful pair of hands is better than rushing it alone. Set the cassette on a flat surface, twist out the stabilising foot if the unit uses one, assemble the pole, then draw the banner up smoothly and hook it into the top rail. Do not yank the graphic up from one corner because that can skew tension across the panel.
Venue floors matter more than many teams expect. A deep uneven carpet, a floor joint under the centre of the cassette or a table leg pushing against the base can make the banner sit slightly off. That can show up in photos even when it seems minor in person, so take a minute to square it properly.
- Leave enough clearance above the unit when lifting the graphic.
- Keep it away from air vents and open exterior doors.
- Do not place stock cartons against the back of the banner.
- Pack only when the print face is clean and dry.
Print handling, storage and reprints
Roll-up graphics last best when they are treated like printed equipment rather than general event luggage. Wipe dust off with a soft dry cloth, keep adhesive labels away from the print face, and never store the cassette loose among metal poles or gazebo weights. After an event, retract the panel slowly so the edges feed in straight. If the banner has picked up grit from a venue floor, clear that first or the particles can mark the graphic as it rolls in.
For teams that exhibit seasonally, reprints can be a sensible option when branding changes but the hardware is still serviceable. Spare parts may also help if a pole section, top rail or carry bag has gone missing between shows. If the cassette has taken a hard knock in transit, mention that when you send your enquiry because a new graphic alone may not solve the issue.
Details to include when asking for a quote
We print in Durban and courier nationwide, so it helps to know both the event use and the delivery town from the start. Tell us whether this banner stands on its own or must match other display items such as flags, gazebos or a fabric backdrop. If artwork is still being prepared, that is fine, but we need enough information to quote the right hardware and print setup.
- Quantity required.
- Delivery town and province.
- Whether you need hardware and print, or a reprint only.
- Event type, such as expo, conference or in-store promotion.
- Any deadline linked to a booking-in date or courier dispatch.
- Whether the banner must match existing display colours or sizing.
You can send those details through our contact form and we will price the unit that suits the job rather than forcing a standard setup where it does not fit quite right.
What our Event Display customers say
Verified Google reviews
Questions we get asked
Can I use a 1 500 mm roll-up outdoors?
It is better kept for indoor use. A light breeze can move a wide panel easily, and outdoor moisture or uneven ground can shorten hardware life.
Is this better than two standard roll-up banners side by side?
That depends on the layout. One 1 500 mm unit gives a cleaner single visual, while two standard units can be easier to carry separately and position in tighter areas.
Can you print a new graphic for my existing wide base?
Yes, if the hardware is still in usable condition and the panel size matches. Send a photo of the base and any old graphic details through our contact form.
Also worth a look




Tell us about the job
Send sizes, materials and where you are through our contact form, and we will come back with the practical options.
Open the contact form
