Durban, printing in-house and couriering displays nationwide to Gauteng, the Western Cape, the Eastern Cape and every other provinceSend an enquiry
Tradeshow Displays

Standard 850 mm roll-up

Our standard 850 mm roll-up is the everyday banner for receptions, expo aisles, mall activations and launch spaces. It packs into a carry bag, sets up in a minute, and gives you a full-height printed panel without needing a custom stand.

a person pulling a printed roll-up banner up from its silver aluminium base and clipping the top rail onto the pole

An everyday banner size that fits most venues

The 850 mm width is the familiar roll-up format used at expos, in foyers and next to promo tables. It is wide enough to carry a headline, one strong image and clear contact or product detail, but still compact enough to move in a small car or carry through a venue entrance without fuss. For indoor campaigns that move from one site to the next, this size makes sense.

It suits teams that need display material ready for repeated use across Durban and further afield. We print the graphic in-house, fit it to the cassette and pack it with the support pole and carry bag. When the artwork stays current for seasonal use, reprints are straightforward if the panel gets marked or your message changes.

  • Typical display width: 850 mm
  • Typical visible height: about 2 000 mm
  • Packed format: cassette, pole and carry bag
  • Best for indoor use on level flooring

Size, layout and the limits of the format

This product is built around a fixed footprint, so the design has to do its work within a narrow portrait panel. The format is good for a bold heading, a short value statement and one main visual. It is less effective when you try to load it with price grids, long paragraphs or too many logos. At reading distance in a busy hall people need the message quickly, and crowded artwork tends to disappear.

The standard 850 mm unit also has practical limits. It is not the right pick when you need a broad branded wall, when the banner must be seen from far across a concourse, or when the venue is exposed to wind. For those jobs a wider roll-up, a fabric backdrop or a gazebo usually makes more sense. If you need a run of matching units for a row behind a registration table, this size works well because each banner is easy to line up and transport.

  • Works well for single-message promotions
  • Less suited to dense catalogues or detailed technical charts
  • Not intended for outdoor wind exposure
  • Best viewed from short to medium indoor distances

Where this roll-up works best

We see the 850 mm roll-up used most often in office reception areas, school and college open days, conference registration points, shopping centre activations and compact expo stands. It also works well beside a product sample table or at the edge of a small presentation area where floor space is tight. In hotel venues and civic halls, the narrow base leaves room for foot traffic and queue barriers.

There are places where it is the wrong tool. Uneven paving, windy entrances and beachfront events around Durban will shorten the life of a standard indoor cassette, and the banner face can flap or lean if the floor is not stable. It also will not replace a full branded shell scheme wall or a custom-built exhibition stand. We supply portable displays only, so if your brief depends on counters, trussing or built structures this page is not the right route.

Set-up on site and the floor space you need

Installation is simple, but a few site details matter. The cassette sits on the floor, the support pole locks into place, and the printed panel pulls up to the top rail. Allow enough clearance above the unit for assembly, especially under low bulkheads or directional signs. You also need a clean dry spot so the base does not pick up grit that can scratch the print on the way back in.

For steady presentation, place it on a level surface away from heavy pedestrian knocks. The footprint is modest, but do not push the cassette hard against a wall if skirtings stop it from sitting flat. In a foyer with polished tiles that get dusty fast, a quick wipe before set-up helps.

  • Allow floor space for the base and a safe standing margin
  • Check overhead clearance before pulling the banner up
  • Use on level indoor flooring for the best result
  • Keep it away from doorway gusts and damp entrances

Looking after the cassette and printed panel

A standard roll-up lasts better when it is handled gently between events. Retract the panel slowly rather than letting it snap into the base, and make sure the print is dry and clean before packing. If the banner has stood in a humid coastal venue, give it a little time to air before storage so moisture does not sit trapped in the bag. Durban conditions can be hard on anything packed away wet.

Store the unit upright or flat where heavy stock cannot fall onto the cassette. Scratches and dents on the housing do not always stop the banner from working, but they can affect how smoothly the mechanism runs. If the print face is damaged and the hardware is still sound, we can replace the graphic rather than discard the full unit. Spare parts and reprints are useful when one banner in a set takes more wear than the others.

Details that help when you enquire

When you send your request through our contact form, include where the banner will be used and whether this is a once-off campaign or part of a set for repeated events. That tells us whether you only need one unit, a matching group, or a broader mix with flags, a gazebo or a pop-up backdrop. If you already have artwork, note the finished size or ask for the artwork guide before final prep.

Useful information from the start saves changes later, and it helps us suggest the right display rather than an awkward fit.

  • How many 850 mm units you need
  • Indoor venue type, such as expo hall, foyer or retail activation
  • Whether you have print-ready artwork or need the size guide
  • Your delivery town or city in South Africa
  • Any matching items needed, such as flags or a backdrop

What our Event Display customers say

Verified Google reviews

Questions we get asked

Can this roll-up be used outside?

It is meant for indoor use. A standard 850 mm cassette is not a good choice for windy outdoor areas, open entrances or uneven paving.

Can I replace only the print later?

Yes, if the hardware is still in decent condition we can supply a reprint panel instead of replacing the whole unit.

Is 850 mm wide enough for an expo stand?

For a single message or side graphic, yes. If you need a stronger back wall effect, look at a wider roll-up or a pop-up backdrop.

Tell us about the job

Send sizes, materials and where you are through our contact form, and we will come back with the practical options.

Open the contact form